IC-A25CE/NE

Disponibilidade: Sob consulta REF: 1117A

Descrição

General

 

IC-A25NE

IC-A25CE

NAV and COM NAV and COM channels COM channels
Frequency range Tx 118.000–136.992 MHz 118.000–136.992 MHz
Rx 108.000–136.992 MHz 118.000–136.992 MHz
Rx (Weather) 161.650–163.275 MHz 161.650–163.275 MHz
Number of memory channels 300 channels/15 groups
Channel spacing 25/8.33 kHz
Type of emission 6K00A3E, 5K60A3E, 16K0G3E (Weather)
Power supply requirement 7.2 V DC (BP-288), 11.0 V DC (External DC Jack)
Current drain (approximately) Tx High Less than 1.8 A
Rx Max. audio/Stand-by Less than 500 mA
90 mA typ. (GPS, Bluetooth, Light: OFF)
Antenna impedance 50 Ω
Operating temperature range −10 °C to +60 °C;
−14 °F to +140 °F
Dimensions
(W × H × D;)
(Projections not included)
58.9 × 148.4 × 31.8 mm;
2.3 × 5.8 × 1.3 in
Weight (approximately) 340 g; 12.0 oz (with BP-288)

Transmitter

 

IC-A25NE

IC-A25CE

Output power (at 7.2 V DC) 6.0/1.8 W typical (PEP/carrier)
Audio harmonic distortion Less than 10% (at 60% modulation)
Hum and noise ratio More than 35 dB
Spurious emissions More than 46 dB
(Except operating frequency ±62.5 kHz
in 25 kHz channel spacing.)
(Except operating frequency ±20.825 kHz
in 8.33 kHz channel spacing.)
Frequency stability ±0.4 kHz

Receiver

 

IC-A25NE

IC-A25CE

Intermediate frequencies 46.35 MHz/450 kHz (1st/2nd)
Sensitivity NAV/COM
(6 dB S/N)
Less than 0 dBμ
WX
(12 dB SINAD)
Less than -8 dBμ
Squelch sensitivity (at threshold) Less than 0 dBμ (AM), Less than -5 dBμ (FM)
Spurious response More than 60 dB (AM), More than 30 dB (FM)
Hum and noise More than 35 dB (at 30% modulation)
Audio output power More than 350 mW typ.
(8 Ω load/60% modulation at 10% distortion)
Ext. speaker connector 3-conductor 3.5 (d) mm (1⁄8ʺ)/8 Ω

Measurements made in accordance with FCC Part87.
All stated specifications are subject to change without notice or obligation.

Applicable U.S. Military Specifications & IP Rating

Icom makes rugged products that have been tested to and passed the following MIL-STD requirements and strict environmental standards.

Applicable U.S. Military Specifications

Standard

MIL-810 G

Method

Procedure
Low Pressure 500.5 I, II
High Temperature 501.5 I, II
Low Temperature 502.5 I, II
Temperature Shock 503.5 I-C
Solar Radiation 505.5 I
Rain Blowing/Drip 506.5 I, III
Humidity 507.5 II
Salt Fog 509.5
Dust Blowing 510.5 I
Immersion 512.5 I
Vibration 514.6 I
Shock 516.6 I, IV

Also meets equivalent MIL-STD-810 -C, -D, -E and -F.

 

Applicable IP Rating

Ingress Protection Standard
Dust & Water IP57 (Dust-protection and Waterproof* protection)
* One meter depth for 30 minutes.